Ingrediënten:
- 210g Kerasoy 4120 Pillar wax
- Bekro Dye chips: Groen, Donkerrood, Oranje
- 12g Cedarwood and Jasmine Fragrance oil (6% fragrance load)
- Wax melt mould- Chocolates
- Kan
- Weegschalen
- Bain marie or double boiler
- Stirring spoon (to be used for wax creations only)
Tip: Pre-heating the moulds with a hairdryer or heat gun before pouring the wax can help improve the overall appearance of the was smelt, allowing them to cool slower.
Stap 1:
Weigh the wax and add to a bain marie or double boiler. Melt at a medium temperature until smooth and duidelijk.
Stap 2:
Next, add the geurolie, this should be added at around 60 degrees but will depend on your chosen fragrance oil and its individual flash point. This needs to be adhered to as every scent has a temperature at which it will start to vaporise and evaporate.
Stap 3:
Add a third of the melted wax to a jug or separate bain marie and add a pinch of dye. Mix this until thoroughly blended.
Stap 4:
Pour at around 55 degrees into the moulds. You could also fill them halfway ready for a different coloured layer to be added on top.
Stap 5:
Repeat steps 3 and 4 with a different dye. This will mean you have 3 different coloured waxes in the Chocolate mould.
Stap 6:
Leave the melts to cure for 24 hours. Then pop out to reveal your wonderfully coloured wax melts ready to add to a wax melt burner.
@cosyowl What colour will these wax melts make? 🍁#autumnwaxmelts #pumpkinspice #diywaxcrafts #waxmeltsmelting ♬ Wildest Dreams – ㅤ
